COC Sub-Tab

<< Click to Display Table of Contents >>

Navigation:  EDGE > Tabs > Field Sample Tab >

COC Sub-Tab

The field samples tab contains COC control options allowing for assignment of sample analysis to the COC. To show the COC control, click Show COC in the upper right corner.

 

25033-FieldSampleTabWithCOC

 

The Field COC control can work with or without SPM. After selecting a sample in the top grid, the COC control will display available analysis for it as well as the COC assignment. Three ways that analysis can be assigned to a sample are:

 

1.Pre-assigned by SPM

2.Pre-assigned to a task

3.Pre-assigned manually by user

 

Including an Existing Analysis

 

If there is SPM or task-based analysis available, it will be shown as that shown above, but the Include check box will not be checked. To assign an analysis to a COC, please select COC from the Current COC drop-down, and check the Include box. If there is no COC, create one using the New button on the COC Tab. Be sure to select the lab when a new COC is created.

 

newCoCbuttons

EDGE-Create_New_COC

 

Notes:

Analysis can be only assigned to  the same lab as the COC. If a sample analysis has no lab assigned, it can be assigned to any COC as long as the COC has a lab assignment.

If no COC is selected, then EDGE will try to determine a compatible COC. A COC is considered compatible if it is the only one in the current EDD with a same analysis for a different sample already assigned to it.

 

Adding New Analysis

 

If required analysis is not present for a selected sample, one can be easily added by completing the steps below.

 

1.Select or create a new COC

2.Click Add the Mag tool

3.Select analysis from the available list and then click the Add button

 

addMagButtons

 

addMagWindow

 

Please contact support@earthsoft.com if you would like to have this feature available in your custom format.